 | Running Average Sets the number of measurements used in calculating the average. Also sets the number of measurements made when Average Mode if set to Single and Run/Hold is toggled from Hold to Run. Enter the desired number by using the keypad, the rotary knob, or the Up/Down arrow keys. Press Enter to set, or press Esc to restore the previous setting. Max Hold Setting Max Hold to On will only display the maximum power level. Turning Max Hold Off will display the current power level. Run/Hold Toggles between Run and Hold. When in Hold mode, pressing this key starts the measurement and provides a trigger. When in the Run mode, pressing this key pauses the sweep. Average Mode Toggles between single measurement and continuous measurements. In Single, each measurement (or series of measurements if Running Average is greater than 1) must be activated by the Run/Hold key. |