 | Limit Active Limit (Upper Lower) This key toggles the active limit line settings to the Upper or Lower limit. Limit State (Off Single Segmented) This key sets the limit line state to Off, Single, or Segmented. See Figure: Limit Line State Menu. Limit line amplitude is stored even when turned off. Note: Both the Upper and Lower limit lines for a trace must be of the same type: either both are Single, or both are Segmented. Move Active Limit Press this key to change the amplitude of the limit line with the Up/Down Arrow keys, rotary knob, or the numeric keypad. If the limit line is divided into segments, then all segments move by the same amount. Edit Segments Press this key to display the Segments menu and a table of limit line segments. Tap a segment (Upper or Lower), and then choose a function from Figure: Limit Line Segments Menu. Limit Alarm (On Off) When turned On, the Limit Alarm sounds a repeating beep when the trace touches the limit line. Pass/Fail Msg (On Off) When turned On, a Pass or Fail message is displayed to indicate whether the trace touches or exceeds the limit line (Fail). Limit Preset Turns the limit line off and clears amplitude information. The next time that a limit line is turned on, it will be displayed at the default location (center of the display). |
