You can recall a previously saved measurement or setup or a screen shot file either from the instrument internal memory or from a removable USB drive. Only one file of any type can be recalled at a time.
Note
Recalling a measurement or setup may change the current instrument settings and turn off any calibration correction. Consider saving the current setup before recalling a file.
Recall a Measurement
1. Press the File(1) key to display the File menu.
2. Press Recall to open the Recall dialog box.
3. Press the Filetype button, then touch Measurement or All to list only measurement files or all file types, respectively.
4. Press the Location button and navigate to the desired measurement file (.dat). Select it, then press Enter (or Recall in the Recall dialog).
In the example below, the selected file is a Cable Loss measurement file located on a removable USB drive.
Recall Dialog Box
5. In the preview screen that opens, press Enter to complete recalling the measurement. To cancel the recall and return to the File Recall menu, press ESC.
The recalled measurement is the purple trace and is overlaid on the current active (yellow) trace. In Figure: Recalled Measurement and Active Trace, the recalled measurement is used to compare the cable loss of two different RF cables. Recalled measurements are automatically saved to trace memory for use in trace match functions. To see the recalled measurement and the current measurement simultaneously, select Trace & Memory in the Trace Display submenu. Refer to Trace.
