VectorStar™ MS464xB Series Microwave Vector Network Analyzer Programming Manual : SCPI Commands : :SENSe{1-16}:SEGMent Subsystem
 
:SENSe{1-16}:SEGMent Subsystem
The :SENSe{1-16}:SEGMent subsystem command is used to query the segmented sweep type as frequency-based or index based on the active sweep.
Limit Line and Segment Subsystems
Related limit line and segment configuration and control subsystems are:
• :CALCulate{1-16}[:SELected]:LIMit Subsystem
• :DISPlay Subsystem
• :SENSe{1-16}:FSEGMent Subsystem.
• :SENSe{1-16}:FSEGMent{1-50} Subsystem.
• :SENSe{1-16}:ISEGMent Subsystem.
• :SENSe{1-16}:ISEGMent{1-50} Subsystem.
• :SENSe{1-16}:ISEGMent{1-50} Subsystem
• :SENSe{1-16}:SEGMent Subsystem
:SENSe{1-16}:SEGment:AVERage[:SWEepbysweep][:STATe] <char>
:SENSe{1-16}:SEGment:AVERage[:SWEepbysweep][:STATe]?
Description
The command turns sweep by sweep averaging ON/OFF for segmented sweep (frequency based and indexed based) for the given channel.
The query outputs the averaging function ON/OFF status for sweep by sweep averaging for segmented sweep (frequency based and indexed based) for the given channel.
Cmd Parameters
<char> ON | OFF | 1 | 0
Query Parameters
NA
Query Output
1 | 0
Range
NA
Default Value
0
Syntax Example
:SENS1:SEG:AVER ON
:SENS1:SEG:AVER?
 
:SENSe{1-16}:SEGMent:TYPe?
Description
Query only. On the indicated channel, outputs the segmented sweep type for the active segment as frequency-based or index-based where:
• FREQ = Frequency-based sweep type
• INDEX = Index-based sweep type
Query Parameters
<char> FREQ | INDEX
Range
NA
Default Value
NA
Syntax Example
:SENS1:SEGM:TYP?