 | High (37–46 dBm) Output Power Press this submenu key to set the output power level within the higher range for both carrier frequencies, F1 and F2. Low (20–37 dBm) Output Power Press this submenu key to set the output power level within the lower range for both carrier frequencies, F1 and F2. Note: Power output value from the test port is twice the set output value. For example, when Setup > Output Power is set to 20 W, total output power is 40 W. 20 W (F1) + 20 W (F2) = 40 W Test Duration Press this submenu key to set the length of time that the test port will deliver power after Test is pressed. Range for the test is 1 second to 1200 seconds. Use the Arrow keys or the number keypad. If you use the number keypad, then the Units Menu is displayed. Note: When Enhanced Resolution is On, Test Duration does not apply, and N/A is displayed. Refer to the Enhanced Resolution submenu key description. High Reflection Bypass When on it disables the auto shutoff when a high reflection event occurs. Enhanced Resolution DTP On Off Press this submenu key to toggle Enhanced Resolution On and Off. The default setting is On. Use this feature to resolve PIM sources that are physically close together. Up to 4 vertical impulse bars in the sweep window mark the predicted distance location of the measured PM sources. When On, DTP measurements are conducted one time only, then the measurement stops, and the results are displayed. Low Resolution DTF On Off Press this submenu key to toggle On and Off Distance-to-Fault measurements through the PIM test port. The default setting is On. DTP Aid |
