The target receiver settings are default as shown in Figure: Target Receiver Settings. But when controlled by SCPI commands, the default setting are ignored and the SCPI command frequencies are used.
Target Receiver Settings
Start Frequency
The Simulator sweep default start frequency.
Stop Frequency
The Simulator sweep default stop frequency.
Options
Displays the options used in a real target receiver scenario.
Omni Antennas
Click the Omni Antennas check box will assume omni-directional transmission. If not checked, then the interferer power depends on the direction between the source and the receiver.
AM Modulation
Click the AM Modulation check box modulates the amplitude of the interference signal.
IQ Download Delay (sec)
To better simulate the return of IQ data, type or select the delay 1 to 60 seconds.
Signal Editor
Click the Signal Editor label displays the Trace View window. See Signal Editor.
