Programming Commands for USB Power Sensors

This chapter describes the supported remote programming commands for each power sensor model. Programming commands are classified into three main groups with the following functions and modes:

General Purpose Commands

Mode Commands

• Continuous Average Mode (CA Mode)

• Time Slot Mode

• Scope Mode

• List Mode

Trigger Commands

• Trigger Source

• Trigger Level

• Trigger Edge

• Trigger Delay

• Trigger Noise Immunity

• Trigger Arming

The MA241xxA series sensor default start up in the HOLD mode (the START command is sent to put the sensor in RUN mode).

The MA242x8A and MA243x0A series sensor default start-up state is RUN mode (the CHOLD command is sent to put the sensor in RUN mode).


	Anritsu Company 1-800-ANRITSU 10450-00019, Rev. T