Press this submenu key to select which marker (1, 2, 3, 4, 5, 6) is active. The underlined marker number is the active marker. See Figure: Marker Selection Box.

Press this submenu key to turn On or Off the selected (underlined) marker in the Marker submenu key.

 

Press this submenu key to turn on a delta marker and to prompt for a delta offset frequency, either positive or negative from the frequency of the currently active marker.

Press this submenu key to place the currently active marker on the highest signal amplitude that is currently displayed on screen.

Press this submenu key to place the currently active marker on the lowest signal amplitude that is currently displayed on screen.

 

Press this submenu key to move markers from one trace to another (when Trace Overlay is On). See Figure: Trace Menu – Distance‑to‑PIM.

Press this submenu key to toggle the marker table On, Off, or on and Large. The Large marker display shows only the x‑axis and y‑axis values of the active marker.

Turns off all displayed markers.

 

 

Press this submenu key to set the resolution to 128 data points

 

Press this submenu key to set the resolution to 255 data points

 

Press this submenu key to display the Cable list box (refer to Figure: Cable List Box, Table of Specifications). Highlight a cable type in the list box and then press the Enter key to use those cable specifications for your measurement.