VectorStar™ MS464xB Series Microwave Vector Network Analyzer Operation Manual : Installation
 
Installation
 
Introduction
Unpacking the Product
Initial Inspection
Preparation for Use
Operating Environment and Power Requirements
Power-On/Power-Off Procedures
Procedure – Power-On to Standby Mode
Procedure – Standby Mode to Operate Mode
Procedure – Operate Mode to Standby Mode
Procedure – Standby Mode to Power-Off
Connecting External Devices
Connecting an External Mouse or Keyboard
Connecting an External XGA/VGA Monitor
Connecting an External Printer
Connecting Other USB Peripherals
GPIB Setup
Configuring the Dedicated GPIB Port
Configuring the IEEE 488.2 GPIB Port
Configuring the VectorStar VNA GPIB Address
Ethernet LAN TCP/IP and USB Setup
Default Plug-and-Play Configuration
Manually Configuring TCP/IP Ethernet LAN Settings
Configuring the Remote Language
Calibration/Verification Interval
Introduction
This chapter provides information for the initial inspection and preparation for use of the VectorStar MS464xB Series VNA and includes information on instrument installation, required operating environment, power requirements, and initial inspection.
After power up, the various power modes are described with general warm-up and calibration time intervals. The preventive maintenance section includes information on cleaning and fuse replacement along with preparation for storage or shipment. General set up procedures are provided for remote programming control over GPIB and Ethernet or USB only networks.