VectorStar™ MS464xB Series Microwave Vector Network Analyzer Calibration and Measurement Guide : AutoCal Calibration
 
AutoCal Calibration
 
Chapter Overview
Automatic Calibrator (AutoCal) Terms
Insertable and Non-Insertable Devices
Auto-Sense
Characterization File
AutoCal Introduction
Transfer Calibration
Calibration Accuracy
AutoCal Components
Connector Care
AutoCal Calibration Parameters and Types
Adapter Removal
Through Options
Test Port Left/Right Naming Assignments
Typical AutoCal Module Connections
Using the AutoCal Module
Available AutoCal Modules and Adapters
Copying the AutoCal Module Characterization File to the VectorStar
Procedure
Loading a Previously Stored AutoCal Characterization File
Procedure
Pre-Calibration Instrument Setup
Segmented Sweep
IF Bandwidth (IFBW) and Averaging
Port Power
Example Procedure
AutoCal—Full Two Port—Internal Thru
Required Equipment
Procedure
AutoCal—Two Port Cal—True Through
Required Equipment
Procedure
AutoCal Module Characterization
Characterization Procedure
Working with Older AutoCal Modules
Auto Calibration Units 36581x and 36582x
Adapter Removal—M-M or F-F Reference Plane with a M-F AutoCal
Adapter Removal Overview
Required Equipment
Prerequisites
Procedure
Chapter Overview
This chapter describes common procedures for both Internal Through and True-Through calibration using Anritsu AutoCal modules including the 36585-Series Precision AutoCal Modules and the 36581KKF Standard AutoCal Module. This chapter provides two examples of using a precision adapter with an AutoCal unit to create difference-gender reference planes as is adapter removal with an AutoCal unit. The chapter concludes with user-based AutoCal module characterization and working with older Anritsu AutoCal units.
.
MS4647B VNA with 36585V-Series Precision AutoCal Module